Quoting turtle's message so it doesn't get forgotten, but is anybody using the innovate ECB gauge complete kit? ECB-1 (BOOST) Ethanol Content & Air/Fuel Ratio Gauge It comes with gauge (fuel temp, boost, ethanol content, O2). Complete kit also comes with MAP sensor and ethanol sensor. Is this everything I need or do I assume I still need a Zeitronix ECA2 Ethanol analyzer?--and anything else I'm forgetting in regards to gauges and flex fuel needs (aside from actual fuel system). Any reviews or suggestions for my gauges?
Quote:
Originally Posted by turtle64b
Would you guys mind sending me some of your data snippets that you send off to be used for tuning? I have an anomaly where one MAF (bank 1) is reading almost a volt lower than the other at times and I wanted to see if anyone else's car was doing the same. Thanks!
I'm at turtle64b@aol.com
EDIT: To follow up on this, it seems that there is not equal flow through the intake Y-pipe.
Swapping MAFs gave the same anomaly on bank 1, swapping the connection moved the anomaly to bank 2, and swapping the MAF while still connected to the same harness also moved the anomaly to the other bank. This means that at idle and light-medium acceleration, air flow through the two branches of intake Y, in my case, are significantly different. Since the Y pipe meets again in the manifold and the air mixes, the bank associated with the MAF that has the anomaly is getting much more air than sensed by its associated MAF and the other bank is getting less. This would explain my lean condition as well as the sometimes very rich condition that happens at idle.
Is anyone else experiencing this? If you look at your datalogs, it looks like one MAF reading out much lower than the other one. This can be dangerous for the engine as one bank will run rich and the other bank will run lean, potentially dangerously.
|
__________________
09 G37S RWD 6MT, Topgunz Supercharger, CJM RFS, Walbro 450, 1050x, Nismo 1.5way LSD, Ecutek FF tuned by Seb IG: G3RSTY7 MyG37.com: RickyBobby
|