I bought the 6MT shifter surround from a forum member without the shift boot and the shift knob from UAM which works well with this mod.
I sent the 6MT shifter surround in to Tony at CFE to cover in clear reflective carbon fiber to replace my 7AT one I had covered and also stitch me up a boot with thread to match my steering wheel.
I started to follow another thread on the forum and remove the 7AT shifter trim and then start to trim off the shifter base to fit the 6MT shifter surround.
Pics were few and difficult to tell how much to trim, so I waited for mine to get back.
The parts came in yesterday and I got to work. OMG, Make sure you are ready to trim. I used an air saw and a Dremmel tool for grinding. All you will cut is plastic.
Attachment 50888Attachment 50889Attachment 50890Attachment 50891Attachment 50892Attachment 50893
Once I got everything trimmed to fit, it was time to move on to the shift knob.
The shift knob installation with the UAM kit is very simple and staight forward.
I added some grease to help it slide easier.
After my first run I had to adjust the position of the stopper with the set screws to where it was almost to the top of the shaft. The car gave me a warning because the button stayed too far in.
Attachment 50894Attachment 50895Attachment 50896
Here are some pics of it all togeter with my new CFE covered cup holder and arm rest cubby.
Attachment 50897Attachment 50898Attachment 50899Attachment 50900Attachment 50901
These are pics of the complete interior.
Attachment 50902Attachment 50903Attachment 50904