Nissan 370Z Forum - View Single Post - [For Sale] Lots of Goodies: Motordyne, Stillen, Soho Motorsports, Enkei Wheels,TBs

vil9j · 12-20-2017, 03:40 PM

All items are located in Southern California Region. NO SHIPPING ON LARGE ITEMS SUCH AS EXHAUST AND EXTERIOR*Photos will be uploaded once all are removed from vehicle. Going back to stock for dealer. LoCal Pick up preferred. Text 9095499376 for quicker response

EXHAUST CLIP: https://youtu.be/VW8cCo8Q8M0

1.Stillen Front Fascia with Brake Duct Fangs, Mesh, and Splitter*Do note that this is a track and daily car. So there are lots of rock chips on the bumper. Mesh on outer edges were trimmed to fit DRLs(custom mounting kit not included for drls).RODS ARE INCLUDED. The end tips where the fender connects to bumper does show some stress cracking in the paint but if you're going to repaint the bumper a good shop should be able fix it. The splitter has taken a beating throughout it's use so it is somewhat warped and scraped. -Sold
Original price($1200+ with body work and accessories)

2. Motordyne Plenum signed by 370z designer Randy Rodriguez and FormulaD Drifter Chris Forseberg-SOLD

3. Motordyne Art Pipes-$SOLD(400 w/ OEM Cats/Test Pipes)

4.Motordyne Y Pipe Resonated-SOLD

5. Beluga Y-Back with custom dump pipe valve opener and switch-250$
Paid Price-$450

6. Injen Long Tube Intake replaced with 3 inch Spectre Air Filters (Modified to not taper at MAF section. Will need a tune after install)-SOLD

7.Soho Motorsports Ported Lower Intake Manifold-$]SOLD

8. Ported Throttle Bodies 63mm *Photo with green in center is oem-SOLD

9. Enkei RS05RR- Gunmetal Rim (Size: Front 18x10 / Offset: +22 / PCD: 5x114.3...Rear:Gunmetal 18x10.5 +15 5x114.3
3/4 Tires are like new. Rears are continental dws and front Lionhart. Not the best but better for the season
Price:SOLD
11. Fly1Motorsports Duckbill. *There is 2 small nicks on the rear and 2 small hairline scrapes that look like they were from rocks or an angry individual with a knife that slid it across. As you can see in the photos they are barely noticeable unless you're told about it or feeling it. Some sections have been touched up - SOLD

12. Fly 1 Carbon Side Blades(Short to allow mudguards)
Driver side has quarter size chip in the very front. Flex cracks in the inner edge due to flexing(noticeable only when upclose).Passenger side was replaced with a new one Sept 2017 - 250$

12-20-2017, 03:40 PM	#1 (permalink)
vil9j Track Member Join Date: May 2013 Location: SoCal Posts: 784 Drives: 370z Cpe Sprt '13 MT Rep Power: 13	Lots of Goodies: Motordyne, Stillen, Soho Motorsports, Enkei Wheels,TBs All items are located in Southern California Region. NO SHIPPING ON LARGE ITEMS SUCH AS EXHAUST AND EXTERIORPhotos will be uploaded once all are removed from vehicle. Going back to stock for dealer. LoCal Pick up preferred. Text 9095499376 for quicker response EXHAUST CLIP: https://youtu.be/VW8cCo8Q8M0 1.Stillen Front Fascia with Brake Duct Fangs, Mesh, and SplitterDo note that this is a track and daily car. So there are lots of rock chips on the bumper. Mesh on outer edges were trimmed to fit DRLs(custom mounting kit not included for drls).RODS ARE INCLUDED. The end tips where the fender connects to bumper does show some stress cracking in the paint but if you're going to repaint the bumper a good shop should be able fix it. The splitter has taken a beating throughout it's use so it is somewhat warped and scraped. -Sold Original price($1200+ with body work and accessories) 2. Motordyne Plenum signed by 370z designer Randy Rodriguez and FormulaD Drifter Chris Forseberg-SOLD 3. Motordyne Art Pipes-$SOLD(400 w/ OEM Cats/Test Pipes) 4.Motordyne Y Pipe Resonated-SOLD 5. Beluga Y-Back with custom dump pipe valve opener and switch-250$ Paid Price-$450 6. Injen Long Tube Intake replaced with 3 inch Spectre Air Filters (Modified to not taper at MAF section. Will need a tune after install)-SOLD 7.Soho Motorsports Ported Lower Intake Manifold-$]SOLD 8. Ported Throttle Bodies 63mm Photo with green in center is oem-SOLD 9. Enkei RS05RR- Gunmetal Rim (Size: Front 18x10 / Offset: +22 / PCD: 5x114.3...Rear:Gunmetal 18x10.5 +15 5x114.3 3/4 Tires are like new. Rears are continental dws and front Lionhart. Not the best but better for the season Price:SOLD 11. Fly1Motorsports Duckbill. There is 2 small nicks on the rear and 2 small hairline scrapes that look like they were from rocks or an angry individual with a knife that slid it across. As you can see in the photos they are barely noticeable unless you're told about it or feeling it. Some sections have been touched up - SOLD 12. Fly 1 Carbon Side Blades(Short to allow mudguards) Driver side has quarter size chip in the very front. Flex cracks in the inner edge due to flexing(noticeable only when upclose).Passenger side was replaced with a new one Sept 2017 - 250$ __________________ POWERTRIX UL COILS W/ SWIFT SPRINGS \| STILLEN PULLEY \| MOTORDYNE INTAKE MANIFOLD \| STILLEN GEN 3 INTAKES \| MOTORDYNE ART PIPES \| MOTORDYNE Y-PIPE RESONATED \| MEISTERSCHAFT MIDPIPE \| MEISTERSCHAFT AXEL-BACK \| NITTO NT-05 TIRES \| SPL REAR-CAMBER-ARMS \| UPREV TUNE\| WHP Last edited by vil9j; 03-06-2018 at 07:58 PM.