A DR gauge how to...
Title should say AFR guage how to:
Ok, I am going to install Motordyne LT headers (midsize headers) along with resonator TPs and I have always wanted to install an AFR guage but I dont know how the sensor gets hooked up. So my question is...
On the right side header I have a bung and on the right side resonated TP i have a bung, same for the left side...however the z needs all of these for its computer so do I need to have a welder install two more, one on each side...or is there a way to split the signal and have the computer and the guage get the same signal from the same sensor? And if so, before or after the cat (if I had a cat)?
/Z/
Last edited by imazman; 10-31-2017 at 08:05 PM.
|