Quote:
Originally Posted by Om_z34
It's actuallly not to bad, you can remove the seat from the stock brackets and use it with the slider and bracket. U cut the slider off and reweld it a little higher up and it will probably cost u around 80 at a shop rather than 300 for brackets. Also u don't need the stock seatbelt but it's very easy to remove and reinstall into the new bracket if u buy one. And after market seats don't usually come with airbags, u will either clear the code so the light doesn't keep flashing or just kinda live with it because u won't have anything to plug into the wiring harness
|
If you want to be cheap and unsafe then sure. Then you are rendering your stock seats useless if you want to sell them. I got my new brackets for $150 from wedge engineering. Some seats wont allow you to transfer the stock belt clip over. My brides didn't have enough room to do that. I am well aware that aftermarket seats don't come with airbags lol. You HAVE to solder in a 4.7ohm resistor to prevent that dash light from flashing.