Nissan 370Z Forum - View Single Post

secondnissan · 09-22-2017, 02:34 AM

2017-09-22 01.52.11.jpg

2017-09-22 01.53.04.jpgHere are some photos of the front bracket being narrowed. I used tin snips to cut the diffuser on the inside of the outside slots . I then drilled two sets of holes to replace the slots that were cut out. Holes are 3/4 of an inch from sides of tab. Holes are 1/4 diameter. For the bracket I used a dremel cutting wheel and cut to match diffuser width and holes. Filed down sharp edges and painted exposed metal with flat black spray paint. Hope to fit it tomorow. Debating whether I want to cut holes for the bottom of mufflers to protrude so I can tuck the diffuser up higher.

09-22-2017, 02:34 AM	#136 (permalink)
secondnissan Base Member Join Date: May 2011 Location: chicago burbs Posts: 70 Drives: 10 370z 7at Rep Power: 14	2017-09-22 01.52.11.jpg 2017-09-22 01.53.04.jpgHere are some photos of the front bracket being narrowed. I used tin snips to cut the diffuser on the inside of the outside slots . I then drilled two sets of holes to replace the slots that were cut out. Holes are 3/4 of an inch from sides of tab. Holes are 1/4 diameter. For the bracket I used a dremel cutting wheel and cut to match diffuser width and holes. Filed down sharp edges and painted exposed metal with flat black spray paint. Hope to fit it tomorow. Debating whether I want to cut holes for the bottom of mufflers to protrude so I can tuck the diffuser up higher. Last edited by secondnissan; 09-22-2017 at 03:01 AM.