Nissan 370Z Forum - View Single Post

TBatt · 08-07-2017, 09:39 AM

I'm hoping someone here has seen this problem.

I replaced the clutch pedal this weekend with an RJM V3 (went from the V1 so I've done this before) and now I can't start the car because I get a press clutch message. I've unmounted the switch from the pedal so that I can hold the plunger down and still I get the clutch warning. I have checked the switch with a meter and it is normally open and when the plunger is depressed it reads less than one ohm resistance so the switch is working.

Next I installed a jumper wire across the wiring harness connector terminals and still get the clutch warning message.

No codes are set according to my OBDII reader.

I'm searching through the FSM and don't see anything about this yet.

Any ideas?

08-07-2017, 09:39 AM	#1 (permalink)
TBatt Track Member Join Date: Apr 2013 Location: Huntsville, AL Posts: 832 Drives: 2019 GT-R Rep Power: 20168	Clutch switch problem I'm hoping someone here has seen this problem. I replaced the clutch pedal this weekend with an RJM V3 (went from the V1 so I've done this before) and now I can't start the car because I get a press clutch message. I've unmounted the switch from the pedal so that I can hold the plunger down and still I get the clutch warning. I have checked the switch with a meter and it is normally open and when the plunger is depressed it reads less than one ohm resistance so the switch is working. Next I installed a jumper wire across the wiring harness connector terminals and still get the clutch warning message. No codes are set according to my OBDII reader. I'm searching through the FSM and don't see anything about this yet. Any ideas? __________________ RJM pedal, Hotchkis Sway Bars, FI TDX, FOG Light, Z1 Slotted Drilled rotors, Stillen SC, Quaife ATB, Z1 Oil cooler, AEM Gauge Set, Galeforce gauge mount, Avant Garde M590 Hypersilver w/RE-11, TopgunZ A2A kit., ECUtek tuned by Seb: ROLL TIDE!