Quote:
Originally Posted by jchammond
Would not be bad to install a pair;as long as they are functional.
over time the sucked oil (blow by from engine) will gum up in the combustion chamber.
unsure your milage on engine or fuel type/quality being used,,,but i've seen lot's more harm than good from the 10% ethanol blended fuel's.
Ethanol fuel (e-85 etc.) work's great when all supporting components are in place for it & the car is tuned for it.....unsure the shelf life or how long you would want it sitting in your tank;as conventional 10% ethanol gas will begin separating as soon as 1 month (+ or - a bit).
I pay more; but continue my ethanol free93 fuel without problems.
The factory fuel system on these car's don't have a return fuel line-as there was one occasion that i had a stumbling under hard load & not accelerating,,,i checked all known connection's from electrical to vacuum & then removed fuel line to rail & purged out some fuel....thinking maybe got some bad gas-but was all clean.
Car ran perfect ever since.
There are way more skilled & knowledgable people on here that have valid input's.
A little more maintenance is required,but catch can's may be a start to prevent gumming up inside the intake system.
Also a failing or clogged fuel system can cause it to go lean & even show mis-fires.
|
Gonna pick up a couple of pcv valves today just as preventative maintenance. I do recall when i had the upper intake manifold off the the chambers on the lower intake manifold leading to bank 2 had quite a bit of oil built up on them while oddly enough the chambers leading to bank 1 barely had any oil build up at all. Not sure if that indicates anything, but still the pcv valves on this car are the originals and the engine has close to 157,000 miles on it. As a side note i have run a couple of cans of fuel system cleaner through the tank before just on the off chance that there was a clog somewhere in the lines back when this all started, but didnt seem to help much