The results are in. I took it to a local shop and did four pulls on the dyno. They connected an air/fuel gauge to the car to monitor the ratio throughout my pulls. They said that it would start out a little lean and then clean up in the higher RPM's and that it's not lean enough to cause any problems. This is good news because now I can wait until the end of the year to get my car tuned. My best pull made 312hp and 237lbs./tq. as seen in the dyno sheet below. This was on my 2017 Nismo 370z with Stillen Gen 3 intakes, Motordyne ART Pipes, and AAM Resonated Short Tails. Not entirely sure if these are decent numbers or not. It was really hot in the shop too.
