View Single Post
Old 06-15-2017, 11:27 AM   #1808 (permalink)
TBatt
Track Member
 
TBatt's Avatar
 
Join Date: Apr 2013
Location: Huntsville, AL
Posts: 832
Drives: 2019 GT-R
Rep Power: 20168
TBatt has a reputation beyond reputeTBatt has a reputation beyond reputeTBatt has a reputation beyond reputeTBatt has a reputation beyond reputeTBatt has a reputation beyond reputeTBatt has a reputation beyond reputeTBatt has a reputation beyond reputeTBatt has a reputation beyond reputeTBatt has a reputation beyond reputeTBatt has a reputation beyond reputeTBatt has a reputation beyond repute
Default

Quote:
Originally Posted by TopgunZ View Post
Looks like you have the extra pulley mod with the 8psi pulley. Im not sure anyone has ran it like that yet. Im surprised there was even enough room to fit the belt inbetween the two. It might smoke it.
5000 miles on mine so far and it is working great. Look at how the belt is threaded through the whole drive system. The belt bend radius is smaller at other points than at the top.

Most of us are using the stock jack shaft pulley diameter (the same as shown in the picture) even if running the 9psi setup because we use the Vortec pulley on the SC drive belt side. Stillen 9psi pulley = $200, Vortec 9psi pulley = $90.
__________________
RJM pedal, Hotchkis Sway Bars, FI TDX, FOG Light, Z1 Slotted Drilled rotors, Stillen SC, Quaife ATB, Z1 Oil cooler, AEM Gauge Set, Galeforce gauge mount, Avant Garde M590 Hypersilver w/RE-11, TopgunZ A2A kit., ECUtek tuned by Seb: ROLL TIDE!

Last edited by TBatt; 06-15-2017 at 11:31 AM.
TBatt is offline   Reply With Quote