vcz28

I have searched throughout this website for settings for those working with Dash Command. I Use an ELM Kobra WiFi transmitter and I am using my iPhone 6s Plus. I have looked high and low for these numbers and hopefully it will save some hassle regarding these numbers. Under vehicle, choose vehicle, choose information, choose advanced settings.

Fuel Tank: 19 gallons
Brake Specific Fuel Consumption: .45 (Recommended by dash command)
Volumetric Efficiency: 85%
MAF PID: Leave blank (unless aftermarket)
MAP PID: Leave blank (Unless aftermarket)
Lambda (Actual) PID: Leave blank (Unless known)
Lambda (Commanded) PID: Leave blank (Unless known)
Tire size specifications: 285/35R19 (Use own tire size/Fronts)
Final Drive Ratios:
Axle Ratio: 3.692
1st Gear: 3.794
2nd Gear: 2.324
3rd Gear: 1.624
4th Gear: 1.271
5th Gear: 1
6th Gear: .794
7th Gear: Leave blank
Curb weight: 3300lb
Additional Weight: 180lb (Use body weight and any additional weight added to
car on a continuous basis. i.e.. subwoofer, dynomat,
any additional weight carried on a consistent basis.
Drag coefficients: .29
Frontal Area: 21.41 Ft2
Maximum Engine Speed: 7500 RPM (Max redline)
Minimum Engine Speed: 650 (Idle, No A/C turned on)
Shift Point: 3000 (Personal preference. This marks the recommended shift points in the shift tab. This is tailored on how you drive. Economy use a
lower setting, Performance, Use a higher setting. The shift portion has some delay when used, so you can use it to save gas or to increase performance.)

I hope this helps many of you in regards to the setting of your 2009-2010 Nismo with Dash Command.