Thread: vvel Tolerance's
View Single Post
Old 06-02-2017, 11:13 PM   #2 (permalink)
StillenZ84
Enthusiast Member
 
StillenZ84's Avatar
 
Join Date: Oct 2014
Location: OKC, OK
Posts: 316
Drives: 2010 370Z 7AT S/C
Rep Power: 18
StillenZ84 has a reputation beyond reputeStillenZ84 has a reputation beyond reputeStillenZ84 has a reputation beyond reputeStillenZ84 has a reputation beyond reputeStillenZ84 has a reputation beyond reputeStillenZ84 has a reputation beyond reputeStillenZ84 has a reputation beyond reputeStillenZ84 has a reputation beyond reputeStillenZ84 has a reputation beyond reputeStillenZ84 has a reputation beyond reputeStillenZ84 has a reputation beyond repute
Default
Quote:
Originally Posted by hc_416 View Post
I wanted to ask if anyone knows what the tolerances from bank one to bank two should be? I am getting almost .75 difference between bank one and bank two. Also is there a reset I could to to get the sensor's to relearn? Thanks for any advice.
What brings up this question? Are you talking about the position sensors on the backside of the VVEL actuator?
__________________
AtA SC|9 lb pulley|2.85" SC|3.47" Jack|E85|CJM S1-SE|ID1000s|Walboro 485|Zeitronix FF|Stillen CBE|AP Racing|Level 10|F.I. Flex plate|Nismo-S tune|EcuTek RaceRom|Sebz|Speed density|Haltech|3GsCustoms Dual pod a-pillar|Carbon Signal GTR gauges|Fujimura|Built| CP Pistons/Carrillo rods|PortPolishHeads/intakes|928motorsports IG: evanosteenz34
StillenZ84 is offline   Reply With Quote