Well hell you should be good then. I say pull the wastegates, take them apart and make sure they're assembled corretly, put in the 5lb springs and then configure the lines the way I showed you. Then set up your boost controller correctly. You said you plumbed all the lines again but did you use new silicone or reuse the old? If you used the old lines did you carefully check each line for holes. I had a small hole near the passenger side wastegate that caused that wastegate to remain closed. It was tiny but I imagine with 23+ psi it expanded enough to cause a ruckus. You're past the hard stuff this is just where it get's tedius and irritating because now you just want to spool.
|