I think it looks pretty good... When I did mine I wasn't sure if the zip ties would last so I tied my heat wrap up with stainless steel wire instead. Not sure if the concern was valid or not. You may as well also wrap that other part of the harness that goes up the back there as well. This is one area where you really can't overdo it.
Keep an eye on the black plastic harness cover on the passenger side.. IIRC the harness isn't even wrapped under there (but my memory of it is fuzzy)... I had to remove mine regardless because it interfered with the manifold, but if it sits anywhere looking at a cherry red turbine it may not survive.
|