SOOOO>>>.<<<< here I am guys, going to need some help since i haven't done this before. I have one bov that is on the driver's side. I have two waste gates on the passengers side by the turbo. Unfortunately they ran the whole set up wrong so my brother and I have to redo it. They feed the BOV off a t that was coming of a vacuum on the back of the manifold; the other line was going to the boost controller. It also looks like they ran the waste gates off of separate t's. I will have to get the G reddy instruction and make sure to do it right. ..... They seem to have a t that they don't need. What I am gong to do is just rerun it. I do have a few questions if I can ask.
What my bother and I did today, was correct the bov by tapping the manifold and running a dedicated line for it. I have gotten to change out the spring yet so I still don't see vacuum. And on to the waste gates....I cant seem to get them to work. I have both ports on the waste-gates hooked up one line down with a t to the WG on the bottom side, and one line with a t coming back up. This is were I get confused. I have a greddy profec, which has a control box with a inline filter. a solonid with port 1 and 3 being used with port two with no plug and left open. I ran the control box line to the nipple on the charge pipe and put the lower WG line to port 3 and the upper WG line to port one. I did it wrong and I know just looking to get it right really need some help.... Thanks guys!
|