I've been saying for a long time now that 3D printers should start making it possible for car enthusiasts to start designing their own interior replacement trim pieces to mod things. But I haven't seen too much of it happening.
This is great! But it made me think and you know what I'd like even better? I wish there was a variation of this cubby that had more of a slot in the bottom of it so an iPhone could slide into place in it, with the Lightning connector sticking up so it would plug in, docking into it.
One of the annoyances I have with my 370Z right now is lack of any good place to put my iPhone 7 Plus. It's just a little bit too wide to stick it in one of the cup-holders. I can put it in the center compartment itself, but then it's not easily accessible - and I'm liable to forget it when I get out of the car.
Quote:
Originally Posted by Botaine
|