View Single Post
Old 04-03-2017, 10:52 PM   #1 (permalink)
vgl08
Base Member
 
vgl08's Avatar
 
Join Date: May 2013
Location: Northern VA
Posts: 39
Drives: 2013 370z Sport 6MT
Rep Power: 12
vgl08 is on a distinguished road
Default Part out! Stillen Supercharger kit, Gen 3 CAI, Hotchkis Sway bars, others

Hi All,
I have a couple of items for sale:
Stillen Supercharger Kit: $4,000 OBO + Paypal fee + ShippingSOLD!
Stillen Gen3 Cold Air Intake: $350 OBO + Paypal fee + ShippingSOLD!
Hotchkis Front/Rear Sway Bars: $300 OBO + Paypal fee + ShippingSOLD!
GT-R Start Button: $20 + Paypal fee + ShippingSOLD!
Beluga Racing Test Pipes: $60 OBO + Paypal fee + ShippingSOLD!
OEM Radio: $65 OBO + Paypal fee + Shipping


Please see notes regarding the items below:

Stillen Supercharger Kit
The kit was installed on my car for about 16 months, maybe 12k miles. In its time it was 99% daily driver with one trip to the Dragon and one track day at Summit Point. After the track day it was louder than normal. When I got home I pulled it apart and one of the bearings had failed. Input bearing if I remember correctly. I replaced all bearings and seals and intended to reinstall but while everything was out I came across a new project and decided instead to sell the Z(it was too boring driving around with no boost!). Still semi regret this but, here we are… If I can’t sell I will probably end up adapting it to my new project S2000. When I had it apart I didn’t see any obvious damage (other than the trashed bearing). It seems that the bearing was the issue since it no longer feels rough nor makes a grinding sound when rotating the pulleys/impeller, however since I never installed it again I wasn’t able to fully test and cannot provide any warranty to its function. In addition the small belt(the one that is attached between the SC and bracket) probably needs to be replaced as it had some cracks it in, although it never failed.

As you can see from the pictures I did my best to label and store everything together as I was taking the kit off of my car to make it as easy as possible for the next person. Other than the items noted below all of the original parts are included. I can’t promise that there isn’t a missing hose clamp or other small part.
-Upgraded Uprev license and cable from Stillen to Osiris Standard License and cable! This license allows you to have your car dyno tuned vs only being able to use the Stillen tune. The license is stored on the cable.
-Turbosmart TS-0203-1022 Kompact 25 mm Dual Port bpv/bov. I can’t remember if I still have the original plastic bpv that came with the kit but I’ll include if I do.
-DOES NOT COME WITH FUEL PUMP. I was lazy and didn’t remove.

Stillen Gen3 Cold Air Intake
Stillen CAI was on the car for about 6 months before I went with the supercharger. There is a small dent in one of the tubes from installation. I tried to get as many angles on it as possible in the pictures below.

Hotchkis Sway Bars
The sway bars were on my car for a little under two years. Don’t think there was any damage to them – just regular wear. I’ll try to get some pictures of them later this week. Comes with the brackets and bushings.

GT-R Start Button
I think this was my favorite mod of all.

Beluga Racing Test Pipes
No issues with them. Installed for less than a month.Will try to get pictures this week.

OEM Radio
Looking to go back to stock? This one is for you!
















































Last edited by vgl08; 04-13-2017 at 02:29 PM.
vgl08 is offline   Reply With Quote