SINISTER

I am unsure if the 370z clutch hydraulics work the same as the the corvette. If it does (I suspect it does) then this method can be performed regularly versus the flush and bleed (which you need an assistant -who follows instructions perfectly , you need to get under the car, and you run the risk of air getting into the system)...If anyone knows please comment.

The corvette clutch hydraulics work as follows.

The clutch hydraulic system consists of a master cylinder and an actuator cylinder.

When pressure is applied to the clutch pedal (pedal depressed), the pushrod contacts the plunger and pushes it down the bore of the master cylinder.

In the first 0.8 mm (0.031 in) of movement, the recuperation seal closes the port to the fluid reservoir tank, and as the plunger continues to move down the bore of the cylinder, the fluid is forced through the outlet line to the actuator cylinder mounted to the driveline support assembly.

As fluid is pushed down the pipe from the master cylinder, this in turn forces the piston in the actuator cylinder outward.

As the actuator cylinder moves forward, it forces the release bearing to disengage the clutch pressure plate from the clutch disc.

On the return stroke (pedal released), the plunger moves back as a result of the return pressure of the clutch.

Fluid returns to the master cylinder and the final movement of the plunger opens the port to the fluid reservoir, allowing an unrestricted flow between system and reservoir.

Summary: Clutch fluid circulates between the master and actuator (slave).

Note: The volume of fluid in the entire system is a very few ounces. One ounce is in the master cylinder reservoir until diminished as you depress the pedal and create the flow described above.