Quote:
Originally Posted by JWillis72
If you are less than 11 lbs of boost you could try the PBV from the Stillen kit, I'm running it on my car and it stays open at idle without any messing with it.
Sent from my iPhone using Tapatalk
|
OK so we removed the spring completely from the BPV as in theory this would leave it completely open at idle...just to see if it made a difference and unfortunately my idle is still higher than normal...it's off by hair at 200-300 RPM so it appears that it may be the Throttle Chambers. Can't thunk of anything else that's gonna effect the Idle. Smoker shows no leaks and as per the code it's thrown there's three reasons this would occurr.
1) Vaccum Leak (ruled out through smoker test)
2) PCV- which no longer is an issue with this kit as it is replaced with the he breather filter that comes with Topz Kit
3) Throttle Chambers.
Just to make sure went ahead and placed the Stillen BPV on....Idle was still the same....1000 RPM or so....Did Idle Relearn via EcuTek and got "Test Failed Unable to complete." But noticed that the Idle dropped.down to 800-850....still a little high as the Nissan states Idle should be 750rpm give or take 50rpm...
Drove the car around til got temps up to opersting then did ECU reset before Idle Learning again. Got same message "Test Failed Idle Relearn Unsuccessful." RPM we back up to 1000-1100 RPM then P0507 code "Idle Air Control System RPM Higher than Expected."