Quote:
Originally Posted by ban25
Was it purely the throttle or were you limited in RPM? Could have been limp mode, especially if it went away when you restarted the car.
|
It was purely throttle. I could get the car to red line if I wanted, but it took a while since I couldn't go wide open on the throttle.
Quote:
|
Originally Posted by bluebadge
The story they told me was that since I had K&N air filters in the car (the oiled kind) that oil had been sucked back into the mass air flow sensor and caused it to go bad.
|
My filters are the dry type so this shouldn't be an issue.
Quote:
|
Originally Posted by Chuck33079
Any pending codes?
|
I just checked for pending codes and there were 2:
P0101 - Mass Air Flow "A" Circuit Range/Performance
P010B - Mass Air Flow "B" Circuit Range/Performance
So I'll check all the wiring, clean the sensors, and check for leaks in the stillen G3 tubes.