View Single Post
Old 12-06-2016, 11:20 PM   #1 (permalink)
jax4557
Base Member
 
Join Date: Nov 2014
Location: Jacksonville
Posts: 102
Drives: 2014 370z Sport M6
Rep Power: 11
jax4557 is on a distinguished road
Default BP v2.0 Intercooler Piping

Hey all,

For various reasons I had my k member cradle out of the car and was cleaning my piping going under the passenger header, over the starter, and out the front towards the fenderwell/intercooler and noticed my piping has bad rubbing on the lower control arm and a small raised area on the steering rack near the knuckle. Does anyone have any ideas on positing this area of the piping better or a flexible product I can put in this section rather than the aluminum piping that comes with the kit? I have played with this several different ways and it seems so tight that even if I could lock it down perfectly so its not touching when I hit boost for the first time it will move and be in contact again...

Also would a Q60 motor mount bracket be the same as one that goes on a 370z VQ block or can that be the reason my motor is leaving to one side in my cradle? My donor motor had one mount that came with and I just added one off my old motor before dropping onto the existing mounts in cradle....

Thanks in advance,
jax4557 is offline   Reply With Quote