View Single Post
Old 10-13-2016, 01:30 AM   #1148 (permalink)
StillenZ84
Enthusiast Member
 
StillenZ84's Avatar
 
Join Date: Oct 2014
Location: OKC, OK
Posts: 316
Drives: 2010 370Z 7AT S/C
Rep Power: 18
StillenZ84 has a reputation beyond reputeStillenZ84 has a reputation beyond reputeStillenZ84 has a reputation beyond reputeStillenZ84 has a reputation beyond reputeStillenZ84 has a reputation beyond reputeStillenZ84 has a reputation beyond reputeStillenZ84 has a reputation beyond reputeStillenZ84 has a reputation beyond reputeStillenZ84 has a reputation beyond reputeStillenZ84 has a reputation beyond reputeStillenZ84 has a reputation beyond repute
Default

Just getting a chance to get on here today but went back after putting a little bigger tensioner pulley on to help prevent slip and made 556/413 on 11.4 psi! Super stoked. Still slipping a little bit so I'm going to go back to the drawing board and find another tensioner pulley I can swap out for a bigger one as the one I already switched out is as big as it can go for that area. Want higher numbers! Lol This is all still with the k&n filter on. Might take it off for this next pull to see the difference it makes.
__________________
AtA SC|9 lb pulley|2.85" SC|3.47" Jack|E85|CJM S1-SE|ID1000s|Walboro 485|Zeitronix FF|Stillen CBE|AP Racing|Level 10|F.I. Flex plate|Nismo-S tune|EcuTek RaceRom|Sebz|Speed density|Haltech|3GsCustoms Dual pod a-pillar|Carbon Signal GTR gauges|Fujimura|Built| CP Pistons/Carrillo rods|PortPolishHeads/intakes|928motorsports IG: evanosteenz34
StillenZ84 is offline   Reply With Quote