First I want to apologize if this post is in the wrong section. I searched for a listing of just dynos but did not find anything, plus I am new to Tapatalk and don't have a good feel for it yet.
Anyway, I have a stock 2011 370Z Nismo that I just had dyno'd in preparation for my Stillen SC install. Will dyno again after install.
My car has 17,400k miles when dyno'd, pulled 3 runs. Over 3 runs, room temp was from ~65-68, engine oil was ~225-235. Dyno was set to 3% load.
Run1: 291.4 Hp @7300 rpm, 247.6 ft-lbs @ 4530 rpm
Run2: 289.9 Hp @ 7300 rpm, 244.8 ft-lbs @ 4565 rpm
Run3: 288.2 Hp @ 7325 rpm, 241.4 ft-lbs @ 4630 rpm
Interestingly, all three runs showed a a small but consistent dip in torque around 4800 rpm. However, I believe these aren't too far off from manufacturer specs.
I will try to post a pic of runs...note, the value is 250 on left side y-axis of graph, it got a little cut off.
/Z/
Sent from my ASUS PadFone X using Tapatalk