Yeah it looks to be installed correctly. Even if that clamp is tight, you can still twist and tighten the Tial. The bottom twists on just like the side does. I had the same issue and it was loose. Just twist the whole BPV and tighten it up. Might not be the issue but worth a shot.
Quote:
Originally Posted by milkcow500
Question for those of you with the Tial QRJ. I'm getting a weird boost loss issue. I've been able to get most of it back by messing around with the couplers and whatnot, but i just wanted to make sure my V band clamp was correct for the bvp.
Did any of you guys have an oring in your setup and is this correct? My clamp is the Tial Sport 001624.
Sent from my SM-N930V using Tapatalk
|
__________________
AtA SC|9 lb pulley|2.85" SC|3.47" Jack|E85|CJM S1-SE|ID1000s|Walboro 485|Zeitronix FF|Stillen CBE|AP Racing|Level 10|F.I. Flex plate|Nismo-S tune|EcuTek RaceRom|Sebz|Speed density|Haltech|3GsCustoms Dual pod a-pillar|Carbon Signal GTR gauges|Fujimura|Built| CP Pistons/Carrillo rods|PortPolishHeads/intakes|928motorsports IG: evanosteenz34
|