View Single Post
Old 08-15-2016, 08:54 PM   #994 (permalink)
TBatt
Track Member
 
TBatt's Avatar
 
Join Date: Apr 2013
Location: Huntsville, AL
Posts: 832
Drives: 2019 GT-R
Rep Power: 20168
TBatt has a reputation beyond reputeTBatt has a reputation beyond reputeTBatt has a reputation beyond reputeTBatt has a reputation beyond reputeTBatt has a reputation beyond reputeTBatt has a reputation beyond reputeTBatt has a reputation beyond reputeTBatt has a reputation beyond reputeTBatt has a reputation beyond reputeTBatt has a reputation beyond reputeTBatt has a reputation beyond repute
Default

Quote:
Originally Posted by Pauly Z View Post
Ok, back from Tampa. Parts are all from Napa.
Pulley- 54 mm #36375
Belt- Micro V 6 rib #061093
You will also need a bolt, washers, and a drive belt pulley spacer.

You need to take your time to ensure that the belt is lined up properly on each pulley. TAKE YOUR TIME or else you could cause some damage.

I have not had one issue with this setup and have no belt slip what so ever.

Sent from my SM-N920V using Tapatalk
Many thanks! The only other pulley I could find was a 50mm but it was way too wide at 1.5 inches where we need 28 mm (1.1 inches). I'll get the pulley from NAPA tomorrow and check out their bolts and such while I'm there.

I have the 8 rib and 6 rib belts on the way. I am trying an experiment to see if I can remove one rib from the 8 rib to make it a 7. If it doesn't work then the 6 will go on.

Question, just how tight does the 8 rib SC belt need to be? Right now mine is very tight. Anyone measured it with a belt tension meter?
__________________
RJM pedal, Hotchkis Sway Bars, FI TDX, FOG Light, Z1 Slotted Drilled rotors, Stillen SC, Quaife ATB, Z1 Oil cooler, AEM Gauge Set, Galeforce gauge mount, Avant Garde M590 Hypersilver w/RE-11, TopgunZ A2A kit., ECUtek tuned by Seb: ROLL TIDE!
TBatt is offline   Reply With Quote