View Single Post
Old 08-15-2016, 04:53 PM   #990 (permalink)
StillenZ84
Enthusiast Member
 
StillenZ84's Avatar
 
Join Date: Oct 2014
Location: OKC, OK
Posts: 316
Drives: 2010 370Z 7AT S/C
Rep Power: 18
StillenZ84 has a reputation beyond reputeStillenZ84 has a reputation beyond reputeStillenZ84 has a reputation beyond reputeStillenZ84 has a reputation beyond reputeStillenZ84 has a reputation beyond reputeStillenZ84 has a reputation beyond reputeStillenZ84 has a reputation beyond reputeStillenZ84 has a reputation beyond reputeStillenZ84 has a reputation beyond reputeStillenZ84 has a reputation beyond reputeStillenZ84 has a reputation beyond repute
Default

Quote:
Originally Posted by TBatt View Post
Here is the picture you asked for.

I don't think the clocking of the volute can be the problem because the J pipe is at least 5-6 inches too short to work. If I connect it to the BOV coupler it will barely reach the 45, not even enough to get it deep enough to be held on by a clamp much less keeping the 45 open during the bend.
From the top this is how far my volute is clocked. Looks like yours needs to go another inch or more. That notch on mine is directly in the middle of the casing.
Attached Images
File Type: jpg Volute.JPG (235.9 KB, 64 views)
__________________
AtA SC|9 lb pulley|2.85" SC|3.47" Jack|E85|CJM S1-SE|ID1000s|Walboro 485|Zeitronix FF|Stillen CBE|AP Racing|Level 10|F.I. Flex plate|Nismo-S tune|EcuTek RaceRom|Sebz|Speed density|Haltech|3GsCustoms Dual pod a-pillar|Carbon Signal GTR gauges|Fujimura|Built| CP Pistons/Carrillo rods|PortPolishHeads/intakes|928motorsports IG: evanosteenz34
StillenZ84 is offline   Reply With Quote