Quote:
Originally Posted by gomer_110
How are you testing the resistors you have in place?
Using the terminals on the connector will give you odd readings that will cause you to think the resistors are bad. Had the same issue when I did mine a few years ago.
|
First I already had my connectors done up and heat wrapped. I then put the leads on the exposed wire from resistor to heat wrapped. The reading was .8-.9. Granted I had already tried testing both connectors with resistors plugged in and the original weight sensor plugged into its connector. I also went thru the reset procedure. I also tried using the leads within the connector and same reading .8-.9 So maybe these blew?
I tested with just the resistor, new one out of package and put one lead on each side and was reading 5.5. How else do you test them?
I ordered some new ones. These were a bit more expensive as they were 4$ for 10 as last ones were like 4$ for 100.
__________________
Injen cold air intakes, Ported upper and lower manifolds, OS Giken LSD, F1 Long Tube Headers, Magnaflow CBE. Natural Baby
Last edited by CJBinder; 08-11-2016 at 09:28 PM.
|