Nissan 370Z Forum - View Single Post

smithmt09 · 08-04-2016, 10:36 AM

Hey everyone, I have a 11 Nismo and I am running the AAM short tails with 4" tips. I was curious if anyone was running the same set up and is able to measure from the furthest back point on the short tails before the pipe bends where the tip is able to be fitted to the edge of the tip of the bumper for me and maybe snap a pic of a ruler next to it. my 4" AAM tips are not really cutting it for me and I found some tips I like that are dual exit(quad tips) only problem is the are 10.25 inches long and I don't know if they are going to fit. I have no problem cutting back the short tail ends to make them shorter I just need to know how far it is before the pipe bends to the bumper to see if its even worth it. the tips are 2. inlet to dual 3.5 exit. I know the ends will fit, im just worried about the length. the tips are also bolt on so worst comes to worst I can put about 2 inches off the inlet of the tip and about the same off the short tails and weld the tips on but would rather bolt them up to keep it rotatable. thanks

Will try and add a pic of what im talking about measuring. (im away for work and don't have access to my car btw)

08-04-2016, 10:36 AM	#1 (permalink)
smithmt09 Base Member Join Date: Jul 2016 Location: Charlotte NC Posts: 70 Drives: 2011 Nismo Rep Power: 9	Exhasut tip size Hey everyone, I have a 11 Nismo and I am running the AAM short tails with 4" tips. I was curious if anyone was running the same set up and is able to measure from the furthest back point on the short tails before the pipe bends where the tip is able to be fitted to the edge of the tip of the bumper for me and maybe snap a pic of a ruler next to it. my 4" AAM tips are not really cutting it for me and I found some tips I like that are dual exit(quad tips) only problem is the are 10.25 inches long and I don't know if they are going to fit. I have no problem cutting back the short tail ends to make them shorter I just need to know how far it is before the pipe bends to the bumper to see if its even worth it. the tips are 2. inlet to dual 3.5 exit. I know the ends will fit, im just worried about the length. the tips are also bolt on so worst comes to worst I can put about 2 inches off the inlet of the tip and about the same off the short tails and weld the tips on but would rather bolt them up to keep it rotatable. thanks Will try and add a pic of what im talking about measuring. (im away for work and don't have access to my car btw)