View Single Post
Old 08-01-2016, 11:50 AM   #925 (permalink)
TBatt
Track Member
 
TBatt's Avatar
 
Join Date: Apr 2013
Location: Huntsville, AL
Posts: 832
Drives: 2019 GT-R
Rep Power: 20168
TBatt has a reputation beyond reputeTBatt has a reputation beyond reputeTBatt has a reputation beyond reputeTBatt has a reputation beyond reputeTBatt has a reputation beyond reputeTBatt has a reputation beyond reputeTBatt has a reputation beyond reputeTBatt has a reputation beyond reputeTBatt has a reputation beyond reputeTBatt has a reputation beyond reputeTBatt has a reputation beyond repute
Default

Dyno run scheduled for Aug 6th at Z1. I hope I have the leaked fixed by then. I'll be pulling the front fascia off this afternoon and going back over all of the couplers. Then I will rig up a pressure test and make sure there are no leaks.

I do remember that a couple of the joints were not all that tight of a fit and I had to really crank down on the clamps. I'm wondering about building up the tube with some tape so that the coupler fits better. I'm thinking that the silicone coupler is not squeezing down smooth on the inside and that may be causing the leaks.

I'm open to suggestions!
__________________
RJM pedal, Hotchkis Sway Bars, FI TDX, FOG Light, Z1 Slotted Drilled rotors, Stillen SC, Quaife ATB, Z1 Oil cooler, AEM Gauge Set, Galeforce gauge mount, Avant Garde M590 Hypersilver w/RE-11, TopgunZ A2A kit., ECUtek tuned by Seb: ROLL TIDE!
TBatt is offline   Reply With Quote