#1383 is installed and sounds fantastic! Install was fairly easy. Soaking the studs/nuts with Liquid Wrench the night before definitely helped. This system is incredibly well made. The power increase is noticeable. It is worth the wait and the cost without hesitation!
One question for those that have done the install (or FI rep)... after installing the heat wrap on the EVAP purge line, and tightening the zip ties, I noticed the line has a small kink in the bend just after exiting the EVAP canister. I don't recall if this was there prior to installing the heat wrap, or if I was a little to strong when tightenning the zip tie and causes the line to pinch slightly and kink. It's not bent over completely or anything, just small kink in the bend. I have no idea if this would affect vapor flow to the engine for burn off or not... Does anyone else see similar small kink in that corner? Thanks! I can try to take a picture of the area, but it's hard to see with the wrap on, more can just feel it.
