View Single Post
Old 05-23-2016, 04:53 PM   #151 (permalink)
sandersd
Enthusiast Member
 
sandersd's Avatar
 
Join Date: May 2014
Location: Houston, TX, USA
Posts: 280
Drives: 2014 370z Nismo
Rep Power: 11
sandersd will become famous soon enoughsandersd will become famous soon enough
Default

Quote:
Originally Posted by gomer_110 View Post
The measurement was taken with the connector off the car. It was done with the resistor in place and without it.

This is what I had inside working with. (not my picture but close enough)



Wasn't trying to start a argument just trying to point out a nuance of doing this DIY.
I studied electronics to work on my guitar amps. For the record you can't measure electrical components (capacitors, resistors) while they are attached in circuit. You have to remove them and measure them individually. You will never get a correct reading while the component is soldered in place in the circuit. It's a pain but that's the way it is.
__________________
2014 370Z NISMO -- HKS Hi-Power Exhaust -- Swift Springs -- BC ER Coilovers -- SPL Suspension Components -- Nismo R-Tune Intake -- Seibon BD CF Hood
sandersd is offline   Reply With Quote