View Single Post
Old 05-21-2016, 02:05 PM   #2 (permalink)
Jhill
Track Member
 
Join Date: Mar 2016
Location: San jose
Posts: 854
Drives: 2013 370z sport
Rep Power: 3384
Jhill has a reputation beyond reputeJhill has a reputation beyond reputeJhill has a reputation beyond reputeJhill has a reputation beyond reputeJhill has a reputation beyond reputeJhill has a reputation beyond reputeJhill has a reputation beyond reputeJhill has a reputation beyond reputeJhill has a reputation beyond reputeJhill has a reputation beyond reputeJhill has a reputation beyond repute
Default

Quote:
Originally Posted by obender66 View Post
Hi all,

I tried to get feedback from Z1 on the issue with no response to multiple messages. So I have to turn to the masses now
I had Z1 oil cooler installed last week by very reputable local shop. Within 30-40km of driving I got a huge oil leak which ended up on my parking floor and sprayed on exhaust(it was smoking!)
Next day I raised the car and located the leaks. Two of the fittings were leaking-as indicated by arrow, where angled elbow goes into the nut. With engine running, leaks were like from running faucet-leaving trail of drops behind the car.

One at the filter plate and one at cooler itself. NOT the threads. I started tightening them little bit by bit-took 3 retightening/test drive sessions to eliminate constant hanging drop. After about 2 hours of city driving this week I rechecked it again-same places still had oil "sweat" and drops on the undertray. Now, they are damn tight and I am afraid that I start breaking things.
Car is built to be track driven and I cannot afford ANY indication that fittings are leaking, even the tiniest bit.
I am considering having completely new hoses built with Aeroquip fittings and hoses to ensure that components match. I am worried though that threads on fittings will not match fittings on the oil cooler/adaptor plate. Will they?
Is there another solution? $ is secondary consideration, I want to have it done right.

Thank you for any input!
Alex

This is direct link to the image:
https://www.flickr.com/photos/sashaa...in/dateposted/
I'm not seeing the leak? It is leaking at where the hose should be compressed by the fitting or leaking at the sand which plate? If at the plate maybe take it apart and apply Teflon pipe thread sealer to the threads on both the sandwhich plate and AN threads? I installed mine about a month ago and then had a little sign of sweating but I have taken the plate on and off multiple times trying to get it routed how I wanted so now I need to recheck after spraying it all down with cleaner.

P.S. I had rerouted mine cause I had it similar to your but did not like that the fitting hangs lower than the subframe. No I have them at 3 o clock and feel much safer about it. Not sure how to add a pic here.
Jhill is offline   Reply With Quote