Quote:
Originally Posted by Dbeckwith
Following. Just ran into the same code and limp mode after an ecutek tune, so I tried the foil for now and rerouted the wires. Will see if it resolves the issue.
|
I've been on a New TB Cable with no Foil Wrap since my last posting. Taken two 500 mile trips .... no issues.
My cable is routed along the existing wire-loom across the top/front of the motor --> away from direct engine block heat.
Be sure to do these:
2003-2011 Nissan 350Z - 370Z Accelerator Pedal Released Position Learning Procedure | Nissanhelp.com
2003-2011 Nissan 350Z - 370Z Throttle Valve Closed Position Learning Procedure | Nissanhelp.com
2003-2011 Nissan 350Z - 370Z Idle Air Volume Learning Procedure | Nissanhelp.com
Read my note on the Idle Air Volume about how long the engine light should blink before going steady ... to make sure it takes properly.
Good luck.
__________________
GTM STAGE II TT, EXTERNAL WASTEGATES, FI 3" TDX, BLITZ EBC, SZ HIGH 5, FI 500E FUEL RETURN, WALBRO 525, ID1050, ZEIT FLEXFUEL E85, SD TUNED with ECUTEK by SEB, SZ HIGH 5 CLUTCH, 2014 NISMO GUNMETAL WHEELS, 2015 NISMO FRONT, REAR, & SIDE SKIRTS
|