For the DIY'ers out there the picture go in order of my cuts
Cut:1 i cut just bellow where the bumper meets the body to keep the mount for the bumper. as well the top most line was first cut do to the unknown as to where the body met the inner fender well
Cut 2: i cut an inch or so down just so i can look behind the body to determine where the body met the well.
Cut 3: i determined the perfect line to follow to cut was the width of electrical tape that is where you will eventually need to cut the well at.
Cut 4: not finished in the picture but right above the blue tape is where i will be cutting the well to finish the cutting.
