The volute was initially touching right after install and I had to move it up 1/2'-3/4" so it wouldn't hit. There was also a place on the cold side where the pipe came through the engine bay that was leaning against the metal. I put a rubber boot in-between them to try to stop it. Also the strut bar was rubbing on the intake right before the TB's, so I added a little padding.
__________________
AtA SC|9 lb pulley|2.85" SC|3.47" Jack|E85|CJM S1-SE|ID1000s|Walboro 485|Zeitronix FF|Stillen CBE|AP Racing|Level 10|F.I. Flex plate|Nismo-S tune|EcuTek RaceRom|Sebz|Speed density|Haltech|3GsCustoms Dual pod a-pillar|Carbon Signal GTR gauges|Fujimura|Built| CP Pistons/Carrillo rods|PortPolishHeads/intakes|928motorsports IG: evanosteenz34
|