View Single Post
Old 04-19-2016, 03:29 PM   #235 (permalink)
StillenZ84
Enthusiast Member
 
StillenZ84's Avatar
 
Join Date: Oct 2014
Location: OKC, OK
Posts: 316
Drives: 2010 370Z 7AT S/C
Rep Power: 18
StillenZ84 has a reputation beyond reputeStillenZ84 has a reputation beyond reputeStillenZ84 has a reputation beyond reputeStillenZ84 has a reputation beyond reputeStillenZ84 has a reputation beyond reputeStillenZ84 has a reputation beyond reputeStillenZ84 has a reputation beyond reputeStillenZ84 has a reputation beyond reputeStillenZ84 has a reputation beyond reputeStillenZ84 has a reputation beyond reputeStillenZ84 has a reputation beyond repute
Default

Topgunz was spot on with figuring out what filter would work best with the air to air setup. Fits almost perfectly and sits in there very snug. From the front you can see that this setup will be getting plenty of cold air. For the filter to fit better and for piece of mind, I used a small 1/8"x 1/2" rubber spacer that I placed on the lip of the supercharger inlet before I slipped on the air filter. This just allowed for a much tighter grip.
Attached Images
File Type: jpg K&N.JPG (655.8 KB, 139 views)
File Type: jpg K&N1.jpg (456.7 KB, 119 views)
File Type: jpg K&N2.JPG (343.2 KB, 133 views)
__________________
AtA SC|9 lb pulley|2.85" SC|3.47" Jack|E85|CJM S1-SE|ID1000s|Walboro 485|Zeitronix FF|Stillen CBE|AP Racing|Level 10|F.I. Flex plate|Nismo-S tune|EcuTek RaceRom|Sebz|Speed density|Haltech|3GsCustoms Dual pod a-pillar|Carbon Signal GTR gauges|Fujimura|Built| CP Pistons/Carrillo rods|PortPolishHeads/intakes|928motorsports IG: evanosteenz34
StillenZ84 is offline   Reply With Quote