Thread: AAM Short Tails Fitment Issues
View Single Post
Old 03-10-2016, 11:38 PM   #2 (permalink)
37zeroZ
Enthusiast Member
 
Join Date: Feb 2010
Location: Dallas
Posts: 346
Drives: Truck
Rep Power: 14168
37zeroZ has a reputation beyond repute37zeroZ has a reputation beyond repute37zeroZ has a reputation beyond repute37zeroZ has a reputation beyond repute37zeroZ has a reputation beyond repute37zeroZ has a reputation beyond repute37zeroZ has a reputation beyond repute37zeroZ has a reputation beyond repute37zeroZ has a reputation beyond repute37zeroZ has a reputation beyond repute37zeroZ has a reputation beyond repute
Default
Quote:
Originally Posted by Ghh0st View Post
Hi folks!

I just installed my short tails on my '13 base and the passenger side seems to be much lower than the drivers (1.5-2" drop). I added the largest hangar washer to the drivers side so it would stop the exhaust from coming in contact with the bumper. The fitment for the drivers side looks perfect.

I don't have photos as it was getting dark when I had to park the Z.

I didn't add a hangar washer to the passenger side and it still hangs lower than the drivers side with the washer. Has anyone else had similar fitment issues?

I can't touch the car until this weekend but I'm just trying to figure out how I went wrong. I will probably start troubleshooting by loosening all the bolts for the hangars and nuts on the exhaust to readjust.

Also, does anyone have the instructions straight from AAM on the install? I found where the instructions would be on their site but it's not available (404).

Thanks!
I had an issue with my install and had to send back for replacement due to fitment issue with one of the tails. The bad tail I received was so far off, that it seemed that it was fabricated for another vehicle. Received my replacement and all fit well.

Recommend that you contact AAM for a replacement tail.
37zeroZ is offline   Reply With Quote