Originally Posted by Spoiler

Finally got mine installed this past Saturday. Installation was easy.

Once the lid was taped off and the holes were located. I predrilled the small holes, then redrilled those 6 holes to the required larger size.

Then I drilled down through the exterior holes to get holes going through the inner trunk sheetmetal. Then I drilled upwards through the inner liner again to get the 3/4" hole needed for my socket to fit up in there.

Used a palm ratchet so I would not overtighten any of the 6 screws. I taped the socket onto my palm ratchet so I wouldn't lose it inside the trunk core, and I also taped each screw on as I pushed them up through the trunk to mate up with the spoiler.

Check out the pictures in my album as to some of the progression..

I really like the spoiler. It looks good, and when it was hand tightened down,
it fit really well to the profile of the trunk.