View Single Post
Old 02-11-2016, 11:19 AM   #2 (permalink)
Tractionless
A True Z Fanatic
 
Tractionless's Avatar
 
Join Date: Jan 2016
Location: Atlantic SE
Posts: 1,326
Drives: '10 K23 ST 7AT
Rep Power: 30525
Tractionless has a reputation beyond reputeTractionless has a reputation beyond reputeTractionless has a reputation beyond reputeTractionless has a reputation beyond reputeTractionless has a reputation beyond reputeTractionless has a reputation beyond reputeTractionless has a reputation beyond reputeTractionless has a reputation beyond reputeTractionless has a reputation beyond reputeTractionless has a reputation beyond reputeTractionless has a reputation beyond repute
Default

Quote:
Originally Posted by FLUJOKE View Post
So I finally powder coated the engine brace cross bar a beautiful candy red but when I tightened the nuts the coated started to chip and flake. I had the guy redo it, but how can I torque this down tight enough w/o it happening again or has this happened to anyone else?


Sent from my iPhone using Tapatalk
Did you use a flat washer so the bolt twists against it rather than the bar?
Tractionless is offline   Reply With Quote