View Single Post
Old 02-10-2016, 08:57 AM   #1316 (permalink)
EVOHUNTER
Track Member
 
EVOHUNTER's Avatar
 
Join Date: Jul 2011
Location: Edmonton, Canada
Posts: 681
Drives: BOOSTED3-7-0
Rep Power: 15
EVOHUNTER is a jewel in the roughEVOHUNTER is a jewel in the roughEVOHUNTER is a jewel in the roughEVOHUNTER is a jewel in the rough
Default

Maybe this will help?

Install a new O-ring to the charge pipe tool NO. 310811EA5A or equivalent. Connect a scan tool to the DLC and monitor transmission fluid temperature. Start the engine and warm the transmission to approximately 104°F (40°C) NOTE: temperature greatly affects fluid level. Ensure temperature remains constant during checking procedure. With vehicle on a level surface shift the transmission through each gear, then return to the P position. Raise the vehicle and remove the overflow checking plug from the pan. Install charge pipe tool NO. 310811EA5A or equivalent. HAND TIGHTEN only. Connect a suitable fluid pump to the charge pipe and add 0.5 liters of the correct fluid to the transmission. Remove the charge pipe. If no fluid flows from the overflow hole Continue adding fluid. Allow fluid to drain until it drips. Install and tighten overflow plug.

this is now much Nissan says it should take.

Liters 9.2 Quarts 9.7

If you don't shift through the gears it wont take all the fluid!
__________________

Last edited by EVOHUNTER; 02-10-2016 at 09:00 AM.
EVOHUNTER is offline   Reply With Quote