i finally got out to shoot the new powder for my Hornady 75gr's. If you remember I was using a powder not recommended but Accurate or Hornady but one that others had tried with 69gr's and i was only getting around 2460ftps with a very compressed load deforming my tips.
I found out RL 15 would work ok. So I loaded up low, medium and high charges per Hornadys 5.56 manual. But my speeds are way way under what they say. The max at 24.9gr should be 2850ftps. I'm only getting 2642ftps. I take it they don't use a 16" barrel then for the manuals and use a 20". I tested my 16" vs 10" and averaged 310ftps slower or 51ftps per inch. So 2642+204=2846 or almost dead on for 24.9gr per Hornady, way to go manual!
Anyways I started loading more powder to see if I could get more speed and watch for signs of over pressure. Was that bad? I got up to 25.5gr and again started to compress the load and deforme the tip a little Speeds got up to 2710 and the cases looked good after being shot but pretty flat primers though but no damage or hurt cases. I ran out of brass but shot 4 rounds at 25.5gr. First cold barrel shot was 3-4" left from shots 2 and 3 which were sub MOA on top of each other. Shot 4 was again 3" away but right of 2 and 3. After writing all this I'm answering my own question probably by saying the charges were to hot and probably wild and the deformed tip probably wasn't helping. Shots 2 and 3 might of just had more room in the case or less deforming making them good at 25.5gr and 2700ftps. So maybe I'll just stick with 24.9gr at 2642ftps with the 75gr bullet and redo the accuracy testing.
FYI every 0.4-0.5gr averaged about 60ftps for all the loads I tried out.
__________________
13 370z-
|