Quote:
Originally Posted by jaytirbhaw
Thanks for the info jwick. Actually trying to setup a low boost setting around 8-10 lbs and a high boost at around 14-16 psi depending on if that gets me to where I want to be. Assuming it will. I don't have the controller installed yet, removed my manual one. running on WG pressure w/ a 7lb and 3lb spring, I'll remove the 3 lb.
|
If you remove the 3# spring then you will just be running the 7lb (0.5bar). That will limit you to 1bar pressure in the future. That's still a lot of psi but on a built motor with lower compression you might not get where you want to be.
I'm not sure what WG you have but there is likely something between 7 and 10. I have the Tial MV-S and there's a 0.6bar spring which is about 8.7lbs. That would probably be the right spring for you. Run 9-10lbs on low boost and it'll still give you the ability to run 16-17 up top.