Thread: Stillen Air to Air setup
View Single Post
Old 08-07-2015, 02:29 PM   #185 (permalink)
JWillis72
A True Z Fanatic
 
JWillis72's Avatar
 
Join Date: Sep 2013
Location: Fort Myers FL
Posts: 2,002
Drives: 2009 370Z yellow 7AT
Rep Power: 45
JWillis72 has a reputation beyond reputeJWillis72 has a reputation beyond reputeJWillis72 has a reputation beyond reputeJWillis72 has a reputation beyond reputeJWillis72 has a reputation beyond reputeJWillis72 has a reputation beyond reputeJWillis72 has a reputation beyond reputeJWillis72 has a reputation beyond reputeJWillis72 has a reputation beyond reputeJWillis72 has a reputation beyond reputeJWillis72 has a reputation beyond repute
Default
Quote:
Originally Posted by TopgunZ View Post
Well last night I decided to pull out the angle grinder and get at that frame lip. Took out a 3" section of it. The volute slips right in place now and the design into the IC will work great. This requires much more effort than cutting plastic off the fan guard. In fact, I still had to cut one of the guards off just so my angle grinder could get a flat plane to cut the lip off at.

However, I am now able to use just a 45* off the SC at an angle down to a 90* then its a straight shot into the front mount. Very minimal bends in this design. Only a total of 135* hot side and only about 30 inches of pipe.

Ill post pics this weekend.
I have been looking at my car and I like your idea. Not only do you end up with less pipe and bends but you also get the top pipe out of the way opening up more air flow coming out of the radiator to my hood vents.
JWillis72 is offline   Reply With Quote