Things have been going back to normal around here lately and there has been some new inspirations to get back on the project. I recently picked up a lower intake manifold 3D scan from a member here which will be nice because I can really fine tune the runner transition there. I am going to have the valvecovers 3D scanned too so I can really hug those... going to send them off right away.
These small things will increase my confidence level in getting it right the first time, which GREATLY motivates the entire project. There is so much programming and setup just to make a prototype for something this complex, that when you KNOW its going to be right, its so much easier to stay on track.
|