Phunk,
Just got done reading the install instructions again (and again). Few questions:
When doing some of the wiring it says to use a volt meter to verify some of the connections when re-wiring the connectors. If you prep enough (take a pic of connector, etc) and just make sure you keep the same OEM pin locations can you get away with not having to use the volt meter? Maybe I'm over simplifying it.
Also similar with checking the Ohms on the level sensor. As long as the level arm can swing freely and you installed correctly why would you need Ohms recorded?
Why do you have to measure the depth of the level sensor (taping it to the ruler)? Is this just to make sure you bent the baffle enough?
Sorry, just trying to get all my ducks in a row.
|