Sorry for the delays in updates. Been a crazy passed two weeks with work and other things going on. So Sunday I finally had time to install my new spoiler. I started masking off the trunk. Centered the wing and traced it. I then made templates on the bottom of the wing so I could mark where I needed to drill.
Drilled out the pilot holes and stuck a small wire in each with the wing setting on the trunk to ensure all holes lined up perfectly and the wing was centered. After that I finished drilling the holes out to the correct size. I then mounted the wing one last time before packing it up for paint. I took a picture of the paint code and also took off the gas door lid so my paint guy could match everything up and dropped everything off to him.
While I'm getting my wing painted I decided it would be kinda neat to color match my new Z1 shift knob. I took it over to my fathers garage and sand blasted it down. Came out ready for some paint.
My GF decided it was time to part ways with her FRS last week. We said our goodbyes to the FRS and traded it in. She picked up a 2013 G37x. Since we were out and about in her new car I decided to go pick up my Rear Work VSKFs from my buddies house. He mounted the new rubbers on it for me. I then had to do the mandatory, " what if" picture with the G
BTW, turns out you can sadly only fit one 18x12 in the truck of the G.
I got home last night and had a bit of time to work on the Z before going to bed. I started removing the center console. Trying to see how much room I have and where I'm going to mount my Hydro, install my switch to disconnect the yaw censor and some other things. I have some ideas on where I'm going to mount it. Going for a clean install. Ordering an ASD hydro today so more to come.
