View Single Post
Old 06-11-2015, 11:48 AM   #11 (permalink)
OldFart
Track Member
 
OldFart's Avatar
 
Join Date: May 2013
Location: Carlisle, PA
Age: 61
Posts: 682
Drives: 2011 Wannabe Nismo
Rep Power: 960
OldFart has a reputation beyond reputeOldFart has a reputation beyond reputeOldFart has a reputation beyond reputeOldFart has a reputation beyond reputeOldFart has a reputation beyond reputeOldFart has a reputation beyond reputeOldFart has a reputation beyond reputeOldFart has a reputation beyond reputeOldFart has a reputation beyond reputeOldFart has a reputation beyond reputeOldFart has a reputation beyond repute
Default

When I was building my Camaro I had a friend that did CAD design, there was a few custom parts we designed and had to get a machine shop involved to do the milling after we settled on something. One of the parts were radiator/fender supports. The going rate at that time was about $120 for a set of billet from 2 of the main stream and were rather plain looking, threw him a case of beer for the design and $20 for the machine work... In most of cases your paying for the machine and the knowledge to set it up.


Last edited by OldFart; 06-11-2015 at 12:01 PM.
OldFart is offline   Reply With Quote