Quote:
Originally Posted by Qwk69
Aluminum. I'm still learning how to TIG. I can't make the "stacked dimes" weld yet on alum.
|
Overall looks extremely nice. As a
constructive criticism (and if I may), I would give it a 8.9 out of 10 due to, as you mentioned "the welds" but if they seal the gap completely then is ok, aluminum clamps instead of zip ties at the joints and the position of the MAF sensors which are not on the same position corresponding to each other.
For being your first job on a intake system, you are light years ahead from most of us in this forum.
Well done sir.