Nissan 370Z Forum - View Single Post - People with Modded Vortech V3 stillen kit chime in!!

airikrankin · 03-10-2015, 01:26 PM

Well the ice would only last long enough for a run. But if all you are concerned about is the intake temp readings, why not pick up 2 maf bungs weld them on the underside of the piping (so out of sight) pick up 2 used mafs then figure out wich wire is used for the temp and run those to them. Or if an aftermarket iat sensor would work use that instead. Still a draw thru maf setup less piping and way cheaper. And it wouldnt look any different

Sent from my iPhone using Tapatalk

03-10-2015, 01:26 PM	#7 (permalink)
airikrankin Base Member Join Date: Jan 2012 Location: pittsburgh Posts: 115 Drives: 12 370z Rep Power: 13	People with Modded Vortech V3 stillen kit chime in!! Well the ice would only last long enough for a run. But if all you are concerned about is the intake temp readings, why not pick up 2 maf bungs weld them on the underside of the piping (so out of sight) pick up 2 used mafs then figure out wich wire is used for the temp and run those to them. Or if an aftermarket iat sensor would work use that instead. Still a draw thru maf setup less piping and way cheaper. And it wouldnt look any different Sent from my iPhone using Tapatalk Last edited by airikrankin; 03-10-2015 at 01:28 PM.