View Single Post
Old 03-10-2015, 12:10 AM   #22 (permalink)
Rangerz
Enthusiast Member
 
Rangerz's Avatar
 
Join Date: Jun 2013
Location: Northern Utah
Age: 59
Posts: 476
Drives: 2012 370 Nismo
Rep Power: 12
Rangerz has a spectacular aura aboutRangerz has a spectacular aura about
Default

I finished up through CF ducts, or nearly did still have a final trim to do around the perimeter. I think they actually turned out pretty well. Light, strong but, they have some slight cosmetic blemishes due to my process that swayed my decision to not use them. If I had a sacrificial front bumper for track only driving they would go on no question.

I used vacuum bagging for my technique , which works very well. Where I went wrong was I didn't leave my base layer of resin on the mold long enough for it to tack up before I applied the CF and wetted it out. I also used some PVA which was purchased last summer and I suspect it wasn't 100% up to the task. I did learn quite a bit on this "PRACTICE" run and am confident the next go around will be cosmetically acceptable.

Below are some pics of the process and the ducts in different stages of this finial stage of the build.

Making a pattern to cut the CF

vacuum bagging in the kitchen


Some various pics





I had fun and learned a lot for a first attempt it went well.
__________________
Stillen Gen III/ NST/ Fast Intentions Non-Res HFC & 12" Resonated CF TDX/ Setreb series 9 OC/ SPL upper control arms/ Whiteline front & rear swaybars/ Uprev tuned by Seb@specialtyZ/ 319HP 262TQ/ Z1 PS Cooler/ Z1 SS Premium break lines/ CJM Road Race pump/Carbotech F:XP10 R:XP8 Nismo OC DIY

Last edited by Rangerz; 03-10-2015 at 01:38 AM.
Rangerz is offline   Reply With Quote